![]() – Verify That Everything Is in PlaceĪfter you complete the steps above and hear that clicking sound, you need to verify that you placed your shield correctly. If you don’t have them aligned there, you will never hear the clicking sound. Remember that the bumps on the shield need to be above the metal brace of the case. You should hear a clicking sound if it goes in correctly. Then, apply force to the opposite lower corner to get it to snap into place. You will have to apply force to the corner of the IO shield, but don’t push too hard so as to not bend anything. First, place your CPU’s case horizontally and slide the IO shield into place. Now you can finally start to install the IO shield. Unscrew the exhaust fan (take pictures of the fan before you unscrew it so that you can replace it easily) and then move on to the next step. ![]() With this fan gone, you will be able to look at the braces from any angle. While we don’t recommend taking anything else out of the case, you can safely remove the exhaust fan that is probably too close to the IO shield brace. It is challenging to install the IO shield for so many people because there isn’t much “wiggle” room in your case. This step is where anyone installing an IO shield usually goes wrong so you have to be extra careful. They also keep everything in place if you were to move your computer. These bumps help prevent the shield from shifting or falling out of the case due to the micro-vibrations of your case. Somewhere on your shield (usually near the edges of the shield), you will see rounded bumps. – Look For the Details on the IO Shieldįor something so simplistic, the IO shield actually contains a lot of information. It may help to get a second set of hands to keep it steady. You need to get it as close to perfect as possible. Once you know, start lining up the IO shield with the motherboard. To figure out the direction your IO shield should go, you need to know where it will sit on the motherboard. Ensure that it goes in the right way because otherwise, you can damage it either going in or going out. Take some time to look at your IO shield and see which way it will go into your CPU’s casing. – Start By Inserting the IO Shield Correctly Remember that you need to be precise and don’t take any shortcuts or call anything “good enough.” It has to be exact. We suggest reading through all these steps before you start. Installing your IO shield shouldn’t take long. ![]() Conclusion: IO Shield Installation Doesn’t Have To Be Hard.What Are the Metal Prongs on the IO Shield? What Do They Do?.IO Shield Installation Frequently Asked Questions.– Look For the Details on the IO Shield.– Start By Inserting the IO Shield Correctly.How To Install IO Shield: 5 Simple Steps. ![]()
0 Comments
Leave a Reply. |